Seametrics Insert Flow Meter
Electromagnetic Insertion Flow Meter
The adapter fitting of the EX sensor is standard male NPT and can be directly threaded into ordinary saddles or threaded weld fittings. The EX115 and 215 include an isolation valve, allowing hot-tap installation, or installation and removal under pressure; a bronze ball valve is standard, with a 316 stainless steel valve option if needed. Reverse flow output and immiscibility are optional.
Electromagnetic Insertion Flow Meter
- Depth adjustable sensors
- EX101 fits any 1-1/2″ pipe fitting (standard saddle, for instance) and adjusts to pipe sizes 3-10″
- EX201 adjusts to pipe sizes 10-48″
- Meter extends only about 1/8 of pipe diameter, minimizing the potential for clogging with debris
- Accept SeaMetrics modules for rate and total indication, 4-20 mA conversion, data logging, and flow switching
- Alternatively, a signal can be sent directly to a PLC or other control
- Available in brass or 316 stainless steel
- Immersibility and reverse flow output available
The
complete lack of moving parts of the EX100/200-Series insertion flow
sensor is the source of its reliability. Brass and stainless steel
models withstand a variety of temperatures, pressure, and chemical
conditions.
The
EX-Series has no rotor to stop turning in dirty water and there are no
bearings to wear out. Like all magmeters, when used in chemical
injection applications, these meters should be installed upstream of the
chemical line (or far enough downstream to allow complete mixing of
fluids before the meter).
A
rapidly reversing magnetic field is produced in the lower housing. As
the fluid moves through this field, a voltage is generated that is
measured and translated into a frequency signal proportional to the flow
rate. This square wave signal can be sent directly to a PLC or other
control or can be converted using any of the Seametrics family of
indicators and converters.
A
modular system of electronics can be attached directly to the flow
sensor or remotely mounted. The Seametrics FT420 provides a full
indication of rate and total, plus 4-20 mA output. The AO55 provides
blind 4-20 mA output, and the DL76 is a battery-powered data logger.
The adapter fitting of the EX sensor is standard male NPT and can be directly threaded into ordinary saddles or threaded weld fittings. The EX115 and 215 include an isolation valve, allowing hot-tap installation, or installation and removal under pressure; a bronze ball valve is standard, with a 316 stainless steel valve option if needed. Reverse flow output and immiscibility are optional.
More info and price please contact marketing@wmablog.com
